glass-transition temperature

英 [ɡlɑːs trænˈzɪʃn ˈtemprətʃə(r)] 美 [ɡlæs trænˈzɪʃn ˈtemprətʃər]

网络  玻璃化转变温度; 玻璃化温度; 软化温度

化学



双语例句

  1. The effect of the sort and content of solvent on kinetics of polymerization, the stabilities and viscosity of copolymer solution, and intrinsic viscosity, molecular weight, glass-transition temperature of copolymer in solution polymerization of MMA-BA-AA has been studied.
    研究了在溶液聚合中溶剂的种类、用量对MMA-BA-AA体系的溶液聚合动力学,聚合物溶液的稳定性、粘度,聚合物的特性粘数、分子量及分子量分布、玻璃化转变温度等性能的影响。
  2. Effects of DDM on polymerization rate, molecular weight, molecular weight distribution, glass-transition temperature ( Tg), minimum film formation temperature ( MMFT) of the emulsion, gel content, swelling ratio and mechanical performance of the latex film were studied.
    研究了DDM对乳液体系聚合速度、分子量及其分布、玻璃化转变温度(Tg)、最低成膜温度(MMFT)、乳胶膜的凝胶含量、溶胀比以及力学性能的影响。
  3. Thermogravimetic behavior, glass-transition temperature and melting point of the chemical blends were measured by TGA and DSC, and still compared with those of mechanical blends.
    用IR和GPC对提纯所得接枝共聚物进行了初步表征,用TGA和DSC对共混物的玻璃化温度、熔点和热失重行为进行了测定,并与相应的机械共混物进行了比较。
  4. The glass-transition temperature of garlic powder and microencapsulated garlic powder measured by DSC were-2.9 ℃ and 112 ℃ respectly.
    DSC测定蒜粉的玻璃化转变温度为-2.9℃,微胶囊化蒜粉的玻璃化转变温度为112℃。
  5. Various factors of influencing the characteristics of the resin, e.g., copolymer composition, glass-transition temperature Tg, were analyzed in detail by various analytical methods, e.g., DSC, IR, as well as chemical methods.
    对影响树脂性能的指标如共聚物组成、玻璃化转变温度Tg等各种因素,采用DSC、IR等分析方法进行了详尽的分析和表证。
  6. It shows that it could well describe the non-Fick and Fick diffusion of gas molecules in dense polymer membranes below the glass-transition temperature of the polymer.
    模型可以描述温度低于聚合物材料玻璃化温度时,气体小分子在聚合物膜中Fick及non-Fick扩散行为。
  7. The results indicated that PET fibers after exposure to UV-radiation exhibited a marked reduction in molecular weight and tensile strength, noticeable decline in glass-transition temperature and melting temperature, but an increase in crystallinity.
    研究结果表明,紫外线辐射后聚酯纤维样品的分子量、强伸度大幅度下降,结晶度有所提高,玻璃化温度、熔点均有所降低。
  8. The glass-transition temperature ( Tg) decreases with increasing of PVP content because crystalline degree of CHI is decreased.
    另外,PVP含量升高使CHI结晶度降低,进而使PVP/CHI凝胶的玻璃化转变温度Tg降低。
  9. Effects of Phase Separation on Glass-Transition Temperature of Glasses
    分相对玻璃转变温度的影响
  10. Glass-transition temperature of the polymer is 130 ℃ and the thermolysis temperature is 244.6 ℃ as analyzed by TG-DSC.
    TG-DSC分析得到聚合物的玻璃化温度为130℃,热分解出现在244.6℃。
  11. DSC analysis exhibited that the microcapsules had high glass-transition temperature and thermal melting temperature, which indicated good storage stability.
    差示扫描量热分析显示,白木通籽油微胶囊的玻璃化转变温度和热溶解温度较高,表明白木通籽油微胶囊在常温贮藏时处于玻璃态,贮藏稳定性较好。
  12. Polyacrylonitrile ( PAN) exhibits high glass-transition temperature, good thermal and chemical stability, resistance to most organic solvents.
    聚丙烯腈(PAN)玻璃态转化温度较高,具有良好的耐热性、耐溶剂、化学稳定性。